RE: [CAD_CAM_EDM_DRO] revive old ball screw stage
The nuts probably have a lot of preload. Measure the amount of movement along the axis of the screw (set an indicator, push first one direction-zero the indicator them push the opposite direction and read the indicator). Odds are that it's less than five tenths (.0005) difference. This was most likely an optical stage of some sort. It should have two ball nuts inside that are screwed to some sort of bracket. You'll need to add or subtract a shim of some sort to loosen the thread up but you'll end up with more movement along the screw axis.
R. Wink
From: CAD_CAM_EDM_DRO@yahoogroups.com [mailto:CAD_CAM_EDM_DRO@yahoogroups.com]
Sent: Friday, July 1, 2016 9:07 PM
To: CAD_CAM_EDM_DRO
Subject: [CAD_CAM_EDM_DRO] revive old ball screw stage
I have a XY stage with 4" travel purchased from ebay about 10 years ago and shelved since then. It was probably old then, it has the round stepper motors but no manufacturer information or date. No matter, I plan to put new steppers on it and put it into service under my surface grinder.
It has 5 tpi ball screws and roller bearings guides, ball bearing thrust bearings.
Here's the problem: the screws are very stiff. I've been spraying WD40 on them and turning them back and forth with an electric drill, but this seems to only made them slightly looser.
The stiffness seems constant throughout the travel. There is no noticeable backlash.
Taking the whole thing apart can be done, but then I'd just have a pile of unaligned parts which would be a pita to reassemble properly.
Any ideas?
This will be put under control of Mach3 and my Xylotex box when it's runs well enough.
Elliot
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2016.0.7640 / Virus Database: 4613/12539 - Release Date: 07/01/16