CAD CAM EDM DRO - Yahoo Group Archive

Other Driver Solutions?

Posted by
on 2016-07-09 09:57:19 UTC

I've had bad luck with my MaxNC mill so I am looking for a different drive system.  Ideally it would run small hydraulic motors which won't burn out in an overload like steppers.  But I'm willing to consider a different stapper system that's cheaper than MaxNC's since I already replaced the driver board and several motors once.  I once saw other systems in a magazine at a now dead machinist's but I don't remember them or the magazine name.  Any leads?


This forum used to be for builders who I hoped might consider mentoring me on the hydraulic solution, if any are still out there, please advise. .I should be able to hook up the chips to control a proportional hydrauliv valve to a Rspberry Pi but I don't know about the position sensors and software to run the G-codes, etc..


Thank you.


Kirk Fraser

Discussion Thread

2016-07-09 09:57:19 UTC Other Driver Solutions? Jon Elson 2016-07-09 11:54:28 UTC Re: [CAD_CAM_EDM_DRO] Other Driver Solutions? 2016-07-09 13:00:41 UTC Re: Other Driver Solutions? Ron Thompson 2016-07-09 13:31:31 UTC Re: [CAD_CAM_EDM_DRO] Re: Other Driver Solutions?