CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Looking for software for Acumtion 4-axis driver

Posted by Jon Elson
on 2018-12-13 10:29:25 UTC
On 12/13/2018 06:27 AM, kmussatt@... [CAD_CAM_EDM_DRO] wrote:

A *long* time ago (circa 2003?) I bought a Sherline multi-axis mill and got the Acumtion controller that attaches to the parallel port of a PC.  Does anyone have a source for the program that runs this?  I'm trying to get this up and going again.  I have everything except the software that ran the motors from the G-code.  Any help is greatly appreciated.


Doesn't this just use software-generated step/direction?  I think that Sherline was using a version of EMC by 2003.  EMC has become LinuxCNC, and MANY improvements have been added.  If the "controller" is in fact just expecting step/direction through the parallel port, then you should be able to load LinuxCNC onto a modern PC with a parallel port, and pick the configuration from the list.  Most PCs today do NOT have built-in parports, so you just get a PCIe plug-in card for it.

See linuxcnc.org to download linuxcnc.

Jon

Discussion Thread

2018-12-13 09:32:28 UTC Looking for software for Acumtion 4-axis driver Jon Elson 2018-12-13 10:29:25 UTC Re: [CAD_CAM_EDM_DRO] Looking for software for Acumtion 4-axis driver Alan Marconett 2018-12-13 10:53:08 UTC Re: [CAD_CAM_EDM_DRO] Looking for software for Acumtion 4-axis driver 2018-12-13 12:59:43 UTC Re: [CAD_CAM_EDM_DRO] Looking for software for Acumtion 4-axis driver