Re: [CAD_CAM_EDM_DRO] "Re" My steppers

No problem, BTW, I run my steppers at 24VDC at about 1.2Amps and they work
fine, They heat up a bit, but not enough to hurt them.

----- Original Message -----
From: <marble_h@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Tuesday, August 22, 2000 5:16 PM
Subject: [CAD_CAM_EDM_DRO] "Re" My steppers


> I guess that means then, they would be to small to use on my Smithy
> 1720. I will use them on the wire EDM I'm tring to make should
> work just great for that for moving the table , Table is only 12"X14"
> with ball screws. When done I will post as many pictures as I can in
> the group. And thanks Art for the come back..
>
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>