CAD CAM EDM DRO - Yahoo Group Archive

Lathe CNC Questions for Dave.

Posted by wanliker@a...
on 2000-08-25 15:37:04 UTC
Questions for Dave Kowalczyk (dkowalcz@...)

Questions,
Is the software set up for threading?
Also you are using a three phase motor variable-reluctance on the X axis, can
the software drive a regular Bipolar stepper on this axis?
Is the output of the computer step and direction signals, and what is the
wiring for them?
I assume the outputs for the pump, spindle, are just a high or low and are
then used to control relays for operation.
I have the Camtronics drivers, will your software work with them? (Step and
direction.)

More questions to follow, said I would prod you....grin.

Please answer via the CAD_CAM_EDM_DRO@egroups.com route so all can receive
the information and will also be in the archives.
Thanks,
bill

Discussion Thread

wanliker@a... 2000-08-25 15:37:04 UTC Lathe CNC Questions for Dave. Dave Kowalczyk 2000-08-26 07:17:56 UTC Re: Lathe CNC Questions for Dave.