Stepper identification for a newbie
Posted by
Guy Lopes
on 2000-08-25 20:13:42 UTC
Hello all!
I am very new to this and am in need of some help with some steppers
that I bought off of ebay. The price was very low so I thought I
couldn't go wrong even if they were junk. The seller told me that he
couldn't get any data on them from the manufacturer as they were
produced as an OEM part.
Here's what I know about them:
They are 1 5/8" square and 1 1/2" in length.
The label on the back says the name 'Astrosyn'
P/N: 147-0106-00
Type: 17PM-K310-P1V
No.: T8805
"Minebea Co. LTD"
"Made in Thailand"
There is a connector on the top with six conductors. The wiring
harness only uses four of them. Looking from the shaft end of the
motor and reading left to right they are colored as:
1- Yellow
2- <not used>
3- Red
4- Blue
5- <not used>
6- Orange
Any help or further source of information on these little gems would
be greatly appreciated.
Thanks from the new "Guy"!
Guy Lopes
guylopes@...
I am very new to this and am in need of some help with some steppers
that I bought off of ebay. The price was very low so I thought I
couldn't go wrong even if they were junk. The seller told me that he
couldn't get any data on them from the manufacturer as they were
produced as an OEM part.
Here's what I know about them:
They are 1 5/8" square and 1 1/2" in length.
The label on the back says the name 'Astrosyn'
P/N: 147-0106-00
Type: 17PM-K310-P1V
No.: T8805
"Minebea Co. LTD"
"Made in Thailand"
There is a connector on the top with six conductors. The wiring
harness only uses four of them. Looking from the shaft end of the
motor and reading left to right they are colored as:
1- Yellow
2- <not used>
3- Red
4- Blue
5- <not used>
6- Orange
Any help or further source of information on these little gems would
be greatly appreciated.
Thanks from the new "Guy"!
Guy Lopes
guylopes@...
Discussion Thread
Guy Lopes
2000-08-25 20:13:42 UTC
Stepper identification for a newbie
Tim Goldstein
2000-08-25 21:12:35 UTC
RE: [CAD_CAM_EDM_DRO] Stepper identification for a newbie
Guy Lopes
2000-08-25 23:05:16 UTC
Re: Stepper identification for a newbie