Re: Lost Steps (Me again)
Posted by
Ozzie@h...
on 2000-08-28 18:50:06 UTC
In my happy state I forgot that I really need EMC to work because I'm
going to closed loop. Already have the card. Encoder motors coming.
Yeeeks!
Jerry
going to closed loop. Already have the card. Encoder motors coming.
Yeeeks!
Jerry
--- In CAD_CAM_EDM_DRO@egroups.com, Ozzie@h... wrote:
> Thank you all for the mountains of thought and communication on my
> problem in setting up my Shoptask CNC.
>
> I tested to the best of my ability nearly all the suggestions,
> testing
> mosfets, turning down current, grounding and regrounding,
re-routing
> wires, changing wire sizes, twisting wire pairs, but none of those
> things would make my little motors run without losing steps.
>
> Then Alan Rothenbush nearly insisted that I try changing software
and
> create a bootable disc with CNCPRO DEMO on it. It works! It works!
No
> question about it, it works! As far as I can see it works perfectly.
>
> Thank you all and thanks to this site. So glad it's here! Special
> thanks to Alan.
>
> So because I'm never totally satisfied, what was/is wrong with my
EMC
> setup???
>
> Jerry
> Too many thank-you's, hunh.
Discussion Thread
Ozzie@h...
2000-08-28 18:43:14 UTC
Lost Steps (Me again)
Ozzie@h...
2000-08-28 18:50:06 UTC
Re: Lost Steps (Me again)
ballendo@y...
2000-08-29 10:02:40 UTC
RE: Re: Lost Steps (Me again)