Re: [CAD_CAM_EDM_DRO] Lathe Software.
Posted by
wanliker@a...
on 2000-09-01 07:10:33 UTC
In a message dated 9/1/00 8:01:54 AM Mountain Daylight Time, wanliker@...
writes:
<<
I wrote to Kelly at: www.kellyware.com , and asked him if there was any
possibility that his KCAM software would be, or could be modified for lathe
operation. I received the following answer, and with his permission I
include it here.
<>
I hope that some of the list members will outline what it would take to
modify a mill program to handle lathe work, or what is needed in a new
program.
<<Hi Bill,
I have no experience with lathes. Could you tell me some of the features you
would look for in that type of software? What would KCam need to begin to
work with lathes?
bill
writes:
<<
I wrote to Kelly at: www.kellyware.com , and asked him if there was any
possibility that his KCAM software would be, or could be modified for lathe
operation. I received the following answer, and with his permission I
include it here.
<>
I hope that some of the list members will outline what it would take to
modify a mill program to handle lathe work, or what is needed in a new
program.
>>Unfortunately I left out the quote.
<<Hi Bill,
I have no experience with lathes. Could you tell me some of the features you
would look for in that type of software? What would KCam need to begin to
work with lathes?
bill