Re: [CAD_CAM_EDM_DRO] Re: master control Safety

Next stop --- EStop.
Sorry, I have been slow about this, I will be adding on in the next few
days. As well as spindle control.

----- Original Message -----
From: <ballendo@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Sunday, September 03, 2000 11:43 AM
Subject: [CAD_CAM_EDM_DRO] Re: master control Safety


>
> Art,
>
> When you gonna give us an Estop? P Port Status register (pin 10,ACK
> in the orig use) makes a good choice for where. Leaves the other 4
> status port pins for home/limit loops.
>
> Ballendo
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>