CAD CAM EDM DRO - Yahoo Group Archive

Re: gearbox and steppers

on 1999-06-25 08:20:30 UTC
Bill,

A number of commercial cnc router systems use a gearbox with their rack and
pinion systems. They should not introduce any additional backlash.

Bob Campbell

----- Original Message -----
From: <WAnliker@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Friday, June 25, 1999 9:05 AM
Subject: [CAD_CAM_EDM_DRO] gearbox and steppers


> From: WAnliker@...
>
> I found a Compumotor Stepper, that would fit a need that I have, but it
has a
> right angle gearbox on it. Will this gearbox introduce extra backlash, or
is
> it something special for steppers, it is driving a ball screw just the
right
> length for my needs.
> Would the gear box be removable? Kind of hard to see as it is still in
the
> unit. Any suggestions comments will be greatly appreciated.
> bill
> List Manager
>
> --------------------------- ONElist Sponsor ----------------------------
>
> With more than 20 million e-mails exchanged daily...
> http://www.onelist.com
> ...ONElist is home to the liveliest discussions on the Internet!
>
> ------------------------------------------------------------------------
> welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe:
> http://www.onelist.com/unsubscribe/CAD_CAM_EDM_DRO
> bill, List Manager
>

Discussion Thread

WAnliker@x... 1999-06-25 07:05:51 UTC gearbox and steppers Robert Campbell 1999-06-25 08:20:30 UTC Re: gearbox and steppers