Re: Encoders from Wirz
Posted by
TADGUNINC@x...
on 1999-06-26 22:59:57 UTC
This is an addendum to my previous question, Servo Systems has a geared head
servo motor with encoder, 24vdc. the torque spec. versus rpm;
RPM TORQUE
285 30
233 125
150 265
THIS IS THE RANGE OF THE MOTOR, the encoder is 100cpr, 1250 cpr after the
gear reduction, would this motor be practical for a table X/Y drive? I am
planning on getting one for my rotary table anyways. Just curious if I should
get two more for table servos
Thanx for all the help!
Tracey
servo motor with encoder, 24vdc. the torque spec. versus rpm;
RPM TORQUE
285 30
233 125
150 265
THIS IS THE RANGE OF THE MOTOR, the encoder is 100cpr, 1250 cpr after the
gear reduction, would this motor be practical for a table X/Y drive? I am
planning on getting one for my rotary table anyways. Just curious if I should
get two more for table servos
Thanx for all the help!
Tracey
Discussion Thread
Roger Brower
1999-06-27 11:51:18 UTC
Encoders from Wirz
Jon Elson
1999-06-26 20:44:00 UTC
Re: Encoders from Wirz
TADGUNINC@x...
1999-06-26 22:39:45 UTC
Re: Encoders from Wirz
TADGUNINC@x...
1999-06-26 22:59:57 UTC
Re: Encoders from Wirz
Ted
1999-06-27 09:19:39 UTC
Re: Encoders from Wirz
Tim Goldstein
1999-06-27 13:39:21 UTC
Re: Encoders from Wirz
Jon Elson
1999-06-27 23:18:06 UTC
Re: Encoders from Wirz
Jon Elson
1999-06-27 23:48:00 UTC
Re: Encoders from Wirz