Re: [CAD_CAM_EDM_DRO] Re: greetings

Here I go again. Whats a preload nut? Would like to see one.



THANKS Dan











Tim Goldstein wrote:

>
>
> An Acme thread is probably what you currently have on your leadscrews. If
> you want to reduce the backlash with your current screws consider adding a
> preload nut to the current nut.
>
> Tim
> [Denver, CO]
>
> > Ray, thanks for the information. I got a question. Whats an
> > ACME THREAD and where can I look at one.
> > Maybe I dont want ball screws but I would like to reduce the
> > backlask on the mill.
> >
> >
> > Thanks Dan
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager