DC servo motors
Posted by
Carlos Guillermo
on 2000-09-29 13:03:39 UTC
To all:
What is a good size for a DC motor to be used on a mill/drill
conversion, to be driven with the Gecko G320/340 drive? Also, any
recommended sources for good deals?
Carlos
[Non-text portions of this message have been removed]
What is a good size for a DC motor to be used on a mill/drill
conversion, to be driven with the Gecko G320/340 drive? Also, any
recommended sources for good deals?
Carlos
[Non-text portions of this message have been removed]