re:small error in previous post " Manual automatic "
Posted by
ballendo@y...
on 2000-10-05 19:01:43 UTC
I wrote:
Let's also assume that we're talking tool movement here, so the real
part is 1/2 tool diameter smaller. OK? Here goes:
Should be:
...the real part is ONE tool diameter smaller.
Or:
...so the part outline is offset by 1/2 tool diameter.
Hey, It was a long post :-)
Ballendo
Let's also assume that we're talking tool movement here, so the real
part is 1/2 tool diameter smaller. OK? Here goes:
Should be:
...the real part is ONE tool diameter smaller.
Or:
...so the part outline is offset by 1/2 tool diameter.
Hey, It was a long post :-)
Ballendo