Re: [CAD_CAM_EDM_DRO] Re: re:OK - you convinced me - was "Automated "Manual ...
Posted by
ptengin@a...
on 2000-10-06 14:25:19 UTC
In a message dated 10/06/2000 8:11:08 AM Hawaiian Standard Time,
bcollier@... writes:
<< In that case, use preloaded nuts to eliminate backlash. But as in the
question before, the inaccuracies in the leadscrew still shouldn't
matter, right?
Yes, as long as you are running closed loop based on linear encoder feed
back, Yes, the leadscrew can be of any accuracy or inaccurracy.
Peter
THRD, Inc.
bcollier@... writes:
<< In that case, use preloaded nuts to eliminate backlash. But as in the
question before, the inaccuracies in the leadscrew still shouldn't
matter, right?
>>Brian,
Yes, as long as you are running closed loop based on linear encoder feed
back, Yes, the leadscrew can be of any accuracy or inaccurracy.
Peter
THRD, Inc.
Discussion Thread
ptengin@a...
2000-10-06 14:25:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: re:OK - you convinced me - was "Automated "Manual ...