Re: [CAD_CAM_EDM_DRO] Re: Series II big stepper details and step mode
Posted by
Darrell
on 2000-10-09 14:44:39 UTC
It is not that we disagree with your statement, it is that
the correct answer is "Bridgeport stepper drivers are full
step". The BOSS 3 through BOSS 5 Series I machines are .001
per step and the BOSS 6 are .0005 per step. The difference
is in the belt pulley size.
Darrell
the correct answer is "Bridgeport stepper drivers are full
step". The BOSS 3 through BOSS 5 Series I machines are .001
per step and the BOSS 6 are .0005 per step. The difference
is in the belt pulley size.
Darrell
----- Original Message -----
From: "eric" <eek105@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, October 09, 2000 1:30 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: Series II big stepper
details and step mode
> Tim Goldstein wrote:
>
> > They are wired as unipolar and I think the only choice
on with
> > unipolar is full step.
> unipolar can be microstepped, no problem. I am pretty
sure you
> can also half step,but if someone else disagrees i'll go
back into
> hiding.
>
> eric
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list
for the discussion of shop built systems, for CAD, CAM, EDM,
and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com,
wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page:
http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>
Discussion Thread
Tim Goldstein
2000-10-09 09:15:05 UTC
RE: [CAD_CAM_EDM_DRO] Re: Series II big stepper details and step mode
eric
2000-10-09 13:21:49 UTC
Re: [CAD_CAM_EDM_DRO] Re: Series II big stepper details and step mode
Darrell
2000-10-09 14:44:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: Series II big stepper details and step mode