Re: [CAD_CAM_EDM_DRO] Moglice question

I just last week recieved a book from Devitt Machinery Co,Auston,PA
1-800-749-3135. The book is called'Machine Tool Way Rebuilding. In it is
shown massive machine tools being rebuild with Moglice. You might check with
it.The book appears to be a manual on the use of Moglice
Larry Ruebush

----- Original Message -----
From: "Doug Harrison" <prototype@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Sunday, October 15, 2000 11:34 PM
Subject: [CAD_CAM_EDM_DRO] Moglice question


> I am working up a bid to rebuild a large press. This machine uses four
100mm columns running in Al-bronze bushings. The columns are badly scored
and the bushings will need replacement.
>
> Rather than making new bushings I would like to repair the originals with
Moglice if possible. Is Moglice suitable for heavily loaded bushings of
this type? The press has a 3ft by 6ft table and is rated at 100 US tons.
Power is hydraulic.
>
> Also, does anyone know of a knowledgable contact at Philly Resins?
> Doug
>
>
> [Non-text portions of this message have been removed]
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>