Re: Wobble Broach

Joe,

Check with Slater for info. Once you understand the principle of
operation it'll be more obvious how to make one. I've seen one that
a guy made where he was broaching fairly large (over 1/2") hexs in
alloy steel as good as a factory model would do it.

Doug

--- In CAD_CAM_EDM_DRO@egroups.com, Joe Vicars <jvicars@c...> wrote:
> I am intrigued, how do I build one?
>
> BillDarby wrote:
>
> > Joe
> >
> > I have been searching my files to find the gentleman that I
corresponded with, re: rotary broaching with no luck. So I did a
search
> > on rotary broaching and found this firm and I think it may be
the same outfit. I think this site will be able to shed some light.
> >
> > http://www.slatertools.com/Pages/nethome.html
> >
> > Bill D
> >
> > Joe Vicars wrote:
> >
> > > Tell me where I can get more info on a wobble broach.
> > > Thanks
> > >
> > >
> > > Welcome to CAD_CAM_EDM_DRO@e...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
> > >
> > > Addresses:
> > > Post message: CAD_CAM_EDM_DRO@egroups.com
> > > Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> > > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> > > List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@a...
> > > Moderator: jmelson@a... [Moderator]
> > > URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> > > FAQ: http://www.ktmarketing.com/faq.html
> > > bill,
> > > List Manager
> >
> >
> > Welcome to CAD_CAM_EDM_DRO@e...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
> >
> > Addresses:
> > Post message: CAD_CAM_EDM_DRO@egroups.com
> > Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> > List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@a...
> > Moderator: jmelson@a... [Moderator]
> > URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> > FAQ: http://www.ktmarketing.com/faq.html
> > bill,
> > List Manager