Double sided milling WAS Re: SuperCam & PCB Trace Milling Software

Howdy! How 'bout a couple of through holes in the board to be used as
locators. When the board is flipped over, use these 2 holes as "witness
marks". Since you know their coordinates, you should be able to line up
the board's coordinate system so the 2 sides are aligned. Just a
thought.

Rick Dulas

Dennis Bohlke wrote:

> I think engraving a double sided board would be a registration
> nightmare, but do
> able.

[Non-text portions of this message have been removed]