CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Double sided milling WAS Re: SuperCam & PCB Trace Milling Software

Posted by Anne Ogborn
on 2000-10-17 21:57:45 UTC
> I am looking for a source of engraving cutters that can be used to engrave
> circuit boards. If you know of any websites that sell them I'd sure like to
> check them
> out.
>

I have some engravers you can try. They're too short for me to use.

Check under engraving supplies in local phone book. Signmakers, trophy
shops, etc all need these.

Annie

Discussion Thread

Rich D. 2000-10-17 21:10:15 UTC Re: [CAD_CAM_EDM_DRO] Double sided milling WAS Re: SuperCam & PCB Trace Milling Software Anne Ogborn 2000-10-17 21:57:45 UTC Re: [CAD_CAM_EDM_DRO] Double sided milling WAS Re: SuperCam & PCB Trace Milling Software