Re: [CAD_CAM_EDM_DRO] 24 volt power supply
Posted by
Ian Wright
on 2000-10-18 01:52:30 UTC
How about an old lorry-type battery charger - you can probably come across
one in a battered case in a scrap yard. Also, if you come across any large
commercial or industrial buildings being demolished, you might find one that
was associated with a big diesel generator.
Ian
--
Ian W. Wright
Sheffield UK
one in a battered case in a scrap yard. Also, if you come across any large
commercial or industrial buildings being demolished, you might find one that
was associated with a big diesel generator.
Ian
--
Ian W. Wright
Sheffield UK
----- Original Message -----
From: "John D. Guenther" <jguenther@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: 17 October 2000 21:11
Subject: [CAD_CAM_EDM_DRO] 24 volt power supply
> Hi all,
>
> Does anyone have any good ideas where I can get a 24 volt power
> supply capable of at least 10 amps?
>
> Can I series connect two 12 volt switchers to get the 24 volts I am
> looking for?
>
> John Guenther
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>
Discussion Thread
John D. Guenther
2000-10-17 13:11:33 UTC
24 volt power supply
Chris Salter
2000-10-17 13:22:54 UTC
Re: 24 volt power supply
Don Carlson
2000-10-17 14:27:36 UTC
Re: [CAD_CAM_EDM_DRO] 24 volt power supply
Jerry Kimberlin
2000-10-17 16:45:59 UTC
Re: [CAD_CAM_EDM_DRO] 24 volt power supply
Ian Wright
2000-10-18 01:52:30 UTC
Re: [CAD_CAM_EDM_DRO] 24 volt power supply
John Guenther
2000-10-18 04:08:36 UTC
RE: [CAD_CAM_EDM_DRO] 24 volt power supply
Doug Fortune
2003-10-07 23:12:14 UTC
Re: 24 volt power supply
wanliker@a...
2003-10-07 23:16:27 UTC
Re: [CAD_CAM_EDM_DRO] Re: 24 volt power supply
marvinstovall
2003-10-08 07:14:49 UTC
Re: 24 volt power supply
notoneleft
2003-10-08 07:14:51 UTC
Re: 24 volt power supply
Travis Pierce
2003-10-14 12:15:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: 24 volt power supply