Re: [CAD_CAM_EDM_DRO] Re: machine design was: Re: Re: re:Re: Lead screws f...
Posted by
ptengin@a...
on 2000-10-29 01:38:58 UTC
In a message dated 10/28/2000 4:46:00 PM Hawaiian Standard Time,
chris@... writes:
<< re: our exchange rate.. Sucks. It was sitting about 50c US to our dollar
for ages, but it's slipped to 39.something..
Cheers, Chris.
* Design engineer, Assembly worker, Cleaner.
* Ohmark Electronics. PO Box 5302, Christchurch, New Zealand.
* http://www.ohmark.co.nz
Too bad they don't sell a lot of CNC stuff "down there". It'd be a bargain
for us.
Peter
THRD, Inc.
USA
chris@... writes:
<< re: our exchange rate.. Sucks. It was sitting about 50c US to our dollar
for ages, but it's slipped to 39.something..
Cheers, Chris.
* Design engineer, Assembly worker, Cleaner.
* Ohmark Electronics. PO Box 5302, Christchurch, New Zealand.
* http://www.ohmark.co.nz
>>Chris,
Too bad they don't sell a lot of CNC stuff "down there". It'd be a bargain
for us.
Peter
THRD, Inc.
USA
Discussion Thread
ptengin@a...
2000-10-29 01:38:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: machine design was: Re: Re: re:Re: Lead screws f...
Chris Hellyar
2000-10-29 21:41:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: machine design was: Re: Re: re:Re: Lead screws f...