Re: [CAD_CAM_EDM_DRO] Lovejoy Couplings

Anilam used them on a lathe I have.
Darrell
http://www.machinemaster.com

From: <jmw@...

>
> Are Lovejoy couplings (jaw on each end w/ an elastomer cross-shaped
> chunk in the middle) suitable for directly connecting a servo motor
> shaft to a leadscrew, or will wind-up of the coupling cause
> positioning problems? If the encoder was on the other end of the
> leadscrew (rather than the other end of the motor shaft), wind-up
> wouldn't matter, would it?
>
> --Jack
>
>
> -------------------------- eGroups

Sponsor -------------------------~-~>

> eGroups eLerts
> It's Easy. It's Fun. Best of All, it's Free!
> http://click.egroups.com/1/9698/4/_/423600/_/973037831/
> ---------------------------------------------------------------------_

->

>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>