Re: [CAD_CAM_EDM_DRO] Oatley Kit
Posted by
m.d.c
on 2000-11-08 06:52:43 UTC
Joe;
I will try to find out tomorrow , I live very close to oatley
regards
mariano
Joe Vicars wrote:
I will try to find out tomorrow , I live very close to oatley
regards
mariano
Joe Vicars wrote:
> Has anyone put together the Oatley Electronics K109 2 axis driver
> kit? I can't figure out what voltage can be supplied to the board.
> The
> Schematic shows a Vcc in three places, but the board only has
> provision
> for one.
> Also, how do you size a fuse for a stepper driver ?
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
Discussion Thread
Joe Vicars
2000-11-08 05:20:29 UTC
Oatley Kit
m.d.c
2000-11-08 06:52:43 UTC
Re: [CAD_CAM_EDM_DRO] Oatley Kit