Re: [CAD_CAM_EDM_DRO] EMCO CNC 5.

Jim,

Contact Don Nichols:

dnichols@...

He has two of these machines and is quite knowledable about them.
I sold him one that had a turret tool post a couple of years ago. The
electronics manual has only block diagrams - not much use for board
repairs.

Bob

At 03:59 PM 11/9/00 +0800, you wrote:

>Hi All.
>
>A couple of years ago when this list was much smaller, I posted a request
>for informationand parts for the EMCO CNC 5 lathe. I did not get a
>response then, but now that the list has grown, I thought I would try again.
>
>The parts I need are:-
>
>1. The Turret / tool changer which mounts on the saddle. I only need the
>mechanics of it, as the machine has the appropriate driver board fitted,
>just no actual tool changer.
>
>2. The technical service manual with circuits etc for the electronics.
>The Australian agents were able to supply the mechanical parts lists etc,
>but not this one.
>
>
>I bought the unit second hand from a college who had managed to lose the
>tool changer (!?), and had no data other than the operators manual - which
>I got.
>
>I will happilly pay a fair price for these items plus shipping to Austarlia
>if anyone has any lying about under a bench somewhere.
>
>Excuse the double posting if you are on both lists.
>
>Jim Gregg.
>
>
>
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>