Re: [CAD_CAM_EDM_DRO] OT: Looking for material
Posted by
Jon Elson
on 2000-11-09 11:55:11 UTC
salterc@... wrote:
shipping might be cheaper than some other non-ferrous dealer.
Their prices are awfully hard to figure out, but tubing seems to be
more expensive than plate. Since I'm in the area, I just go down there
and fish through the cutoffs bins. They give a better price for a
random length end off the rack. They have enough junk from
McDonnell-Douglas (now Boeing) in the basement to build an F-15,
or at least it looks like that!
Jon
> This is the supplyer I use , they will cut any size...They are in St. Louis, MO., so you can use that info to decide if the
>
> http://www.shapirosupply.com/
>
> Check them out,, I know they had some 3" x .022, .065 & .125
shipping might be cheaper than some other non-ferrous dealer.
Their prices are awfully hard to figure out, but tubing seems to be
more expensive than plate. Since I'm in the area, I just go down there
and fish through the cutoffs bins. They give a better price for a
random length end off the rack. They have enough junk from
McDonnell-Douglas (now Boeing) in the basement to build an F-15,
or at least it looks like that!
Jon
Discussion Thread
salterc@v...
2000-11-09 08:26:12 UTC
Re: [CAD_CAM_EDM_DRO] OT: Looking for material
Jon Elson
2000-11-09 11:55:11 UTC
Re: [CAD_CAM_EDM_DRO] OT: Looking for material
Andrew Werby
2000-11-10 11:11:12 UTC
Re: OT: Looking for material