Re: worm drive - a bit more
Posted by
ballendo@y...
on 2000-11-11 16:42:53 UTC
Ian wrote:
and hadn't been able to find any source for the knurls...
Ballendo (learnin',learnin', learnin')
>So I made a steel 'wormwheel' using a small tap - hardened andCool! Thank you for the info! I'd seen these knurls on older tools,
>tempered it, and used it as a knurling wheel. The finished result
>was almost identical to the remaining original screws.
and hadn't been able to find any source for the knurls...
Ballendo (learnin',learnin', learnin')