CAD CAM EDM DRO - Yahoo Group Archive

Re: Taig mill (ballscrews)

Posted by Tony Jeffree
on 2000-11-13 23:39:35 UTC
At 03:09 14/11/00 +0000, you wrote:
>While the Taig uses 3/8" screws, the BSA XC screws might be an easier (and
>cheaper) retrofit than ball screws.

They are 1/2" diameter 20 TPI screws on the Taig, I think you will find.


Regards,
Tony

Discussion Thread

ballendo@y... 2000-11-11 03:44:12 UTC Re: Taig mill (ballscrews) Dennis Bohlke 2000-11-12 15:38:48 UTC Re: [CAD_CAM_EDM_DRO] Re: Taig mill (ballscrews) Tony Jeffree 2000-11-13 06:39:59 UTC Re: Taig mill (ballscrews) Mike 2000-11-13 12:19:04 UTC Re: Taig mill (ballscrews) Smoke 2000-11-13 12:33:14 UTC Re: [CAD_CAM_EDM_DRO] Re: Taig mill (ballscrews) Mike 2000-11-13 12:41:41 UTC Re: Taig mill (ballscrews) Smoke 2000-11-13 12:45:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Taig mill (ballscrews) Tony Jeffree 2000-11-13 23:39:35 UTC Re: Taig mill (ballscrews)