Re: [CAD_CAM_EDM_DRO] MaxNC DLX

Alan;
I have Maxnc dlx step&dir and yes it uses the same parallel port and the 4th axis is called
A , regarding the pin outs here they are
1 m3 output,2 x step,3 xdir,4 y step, 5 y dir., 6 z step, 7 z dir., 8 a step, 9 a dir,10 limit
sw pos, 11 input for m6, 12 limit sw neg., 13 g61 switch sensor, 14 m4 output,
15 nc, 16 m7 output, 17 m8 output, 18 all sig ground, 19-25 nc
regards
mariano



Alan Marconett KM6VV wrote:

> Ron (or anyone),
>
> On your old MaxNC DLX (step/dir), Do you have 4th axis step/dir pins on
> the SAME parallel port connector as XYZ? If so, did they use pins 8 &
> 9? Or was it on another connector? I'm trying to be compatible with
> SOME kind of standard! I have the spec for MaxNC-PRO pinout (step/dir),
> and 4-phase as well. NO DLX!
>
> I'd also like to know if they call the 4th axis 'W' ? and if so, if XYZ
> and ABC are respective, what goes with 'W'? @? Probably not!
>
> Tnx,
>
> Alan, (jogging along)
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager