High Speed engraving spindles
Posted by
ballendo@y...
on 2000-12-14 16:41:47 UTC
John,
This looks 'slick'. I like the way the high speed is still on the
original 'centerline'. coupla questions:
Is the 'revolving center' what we would call a "live center", as used
in a lathe? And you replaced the "live" part with the engraving
cutter holder? Which has provision for the vee- belt also? If so,
this might be a single bearing (radial) setup. Runout is not a
problem? Or is it a higher end (like Royal Mfg.) live center with
multiple bearings? (although your dwg. shows only two).
I like it! Thank you.
Ballendo
This looks 'slick'. I like the way the high speed is still on the
original 'centerline'. coupla questions:
Is the 'revolving center' what we would call a "live center", as used
in a lathe? And you replaced the "live" part with the engraving
cutter holder? Which has provision for the vee- belt also? If so,
this might be a single bearing (radial) setup. Runout is not a
problem? Or is it a higher end (like Royal Mfg.) live center with
multiple bearings? (although your dwg. shows only two).
I like it! Thank you.
Ballendo
>I though I might share this with the list.
>I often have to do some engraving work and my big Beaver has a top
>spindle limit of 4,500 rpm and at that speed it isn't happy.<snip>
>So I then built an add on attachment for the quill.
>John S
Discussion Thread
John Stevenson
2000-12-14 16:09:07 UTC
High Speed engraving spindles
ballendo@y...
2000-12-14 16:41:47 UTC
High Speed engraving spindles
Smoke
2000-12-14 18:21:12 UTC
Re: [CAD_CAM_EDM_DRO] High Speed engraving spindles