CAD CAM EDM DRO - Yahoo Group Archive

Re: Power Torroids

Posted by Charles Gallo
on 2000-12-22 17:03:46 UTC
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On 2000-12-22 CAD_CAM_EDM_DRO@egroups.com wrote:

<snip>
> These toroids wouldn't be suitable for operation directly at line
> currents, as at 60Hz, they would saturate (fail to do their job,
> heat up etc.) at very low current levels. Worse at 50Hz.

> The amount of Iron is decreased as the frequency goes up
> which is why 400Hz is found in aircraft power systems.
> Less weight to get off the ground.

> But I stand with the others - if you can find power toroids
> suitable for AC mains operation at the power levels you
> need, it might be fun to wind a few hundred or thousand
> turns of wire. I'd rather be making chips, myself.... / mark

<snip>

I hint to look for power torroids - If you can find just about
anything from the company "Astrosystems" will have some

Charlie

-----BEGIN PGP SIGNATURE-----
Version: PGP 6.5i
Comment: E-Mail Not Valid Unless Signed

iQA/AwUBOkP7dXrFNodJLHOCEQL0+QCfeIhBCH8SfFvIc74IX0iaZZNpML8AoJYc
Qnr5xjq8/8pl36GxEM8Dhouv
=lPmJ
-----END PGP SIGNATURE-----

Discussion Thread

Charles Gallo 2000-12-22 17:03:46 UTC Re: Power Torroids