re;Re: Re: G-code user variables; convention?
Posted by
ballendo@y...
on 2001-01-06 22:09:28 UTC
Brian P wrote:
It is interesting to note that some of the parameters of different
controls use the same numbering. I first realised this while looking
at the EMC code, which has an array of about 5400 'slots' for params.
Many of these numbered params are the same in Haas and fanuc, and of
course, Allen-Bradley controls...
Hope this helps.
Ballendo
>there are usually several sets of parameters in the control but notAlan, Brian, List,
>all of them can be set or changed by program macros (nor should they)
It is interesting to note that some of the parameters of different
controls use the same numbering. I first realised this while looking
at the EMC code, which has an array of about 5400 'slots' for params.
Many of these numbered params are the same in Haas and fanuc, and of
course, Allen-Bradley controls...
Hope this helps.
Ballendo