Re: [CAD_CAM_EDM_DRO] BDI emc
Posted by
Joe Fahy
on 2001-01-14 12:02:52 UTC
Hi Paul,
Would you please tell me if and how I can receive a copy? On the if,
please;) On the how, how much do I make the check for & where do I send it.
Thanks for going through the push-ups of doing all this work.
Joe Fahy
4076 Penns Valley Road
Spring Mills, PA 16875
814.422.8210 voice
814.422.8135 fax
Would you please tell me if and how I can receive a copy? On the if,
please;) On the how, how much do I make the check for & where do I send it.
Thanks for going through the push-ups of doing all this work.
Joe Fahy
4076 Penns Valley Road
Spring Mills, PA 16875
814.422.8210 voice
814.422.8135 fax
----- Original Message -----
From: "Paul" <Paul.Corner@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Sunday, January 14, 2001 1:09 PM
Subject: [CAD_CAM_EDM_DRO] BDI emc
>
>
> Hi All
>
> Just a quick update after an all night session on this BDI project.
> The kernel is compiled and the rpm built. Along with the emc rpm I put
together
> over xmas, the install shell seems to work fine.
> I need to rebuild the emc rpm and include some desktop icons along with
the
> latest cvs commits (and find out why an important binary is missing).
>
> Running through the BDI install from start to finish takes about ten
minutes on
> a P166 with 32Mb ram and an old 420Mb ide disk.
>
> I should be ready to ship some beta CDs by the end of the week all going
well.
> My thanks to Will & Fred at NIST for the scripts that have made it so much
> easier.
>
> Regards, Paul.
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
Discussion Thread
Paul
2001-01-14 11:17:48 UTC
BDI emc
Joe Fahy
2001-01-14 12:02:52 UTC
Re: [CAD_CAM_EDM_DRO] BDI emc
John Guenther
2001-01-14 12:06:37 UTC
RE: [CAD_CAM_EDM_DRO] BDI emc
Paul
2001-01-14 14:10:22 UTC
Re: [CAD_CAM_EDM_DRO] BDI emc
Marco C. Mason
2001-01-18 20:59:34 UTC
Re: BDI emc