Re: [CAD_CAM_EDM_DRO] : re:Re: Low cost coolant pump and tank
Posted by
Smoke
on 2001-01-20 15:29:28 UTC
My mill came with an oil drip cutting oil system. I've never used it but
it's easy to install and if I wanted to "recirculate" the cutting oil, all
I'd have to do is "mount" a small tin can on the floor near the mill and run
a piece of tubing from the mill table drain hole to the tin can. Oil pumps
are really cheap...just pick up the can now and then and pour the oil back
into the upper reservoir. :)
You could build your own oil drip system with a tin can and some flex
tubing. The flow regulator could be made from a set screw.
Smoke
it's easy to install and if I wanted to "recirculate" the cutting oil, all
I'd have to do is "mount" a small tin can on the floor near the mill and run
a piece of tubing from the mill table drain hole to the tin can. Oil pumps
are really cheap...just pick up the can now and then and pour the oil back
into the upper reservoir. :)
You could build your own oil drip system with a tin can and some flex
tubing. The flow regulator could be made from a set screw.
Smoke
Discussion Thread
ballendo@y...
2001-01-20 14:47:08 UTC
: re:Re: Low cost coolant pump and tank
Smoke
2001-01-20 15:29:28 UTC
Re: [CAD_CAM_EDM_DRO] : re:Re: Low cost coolant pump and tank