Re: Nice results From Dan's kits
Posted by
Donald Brock
on 2001-01-22 21:54:09 UTC
We had some 1.250" x 1/2 " aluminum bar and some 1/8" aluminum sheet
aroundthe shop. The heat sink/mounting brackets are actually made
from 3 separate peices. The bottom plate screws to each heatsink with
3 screws per side. I used 6-32 flat head screws but 5-40's would have
probably been the wiser choice. The circuit board is screwed to each
heatsink with nylon screws and a nylon spacer underneath the board. I
have more detailed pictures and cad drawings for these if any one
wants them. There is a small 3/16 W X 1.32 Dp clearance cut into the
heatsink next to each screw as there is a ground circuit on the edge
of the board at each screw. The clearance cut keeps circuit ground
from coming into contact with chassis ground.
Don
aroundthe shop. The heat sink/mounting brackets are actually made
from 3 separate peices. The bottom plate screws to each heatsink with
3 screws per side. I used 6-32 flat head screws but 5-40's would have
probably been the wiser choice. The circuit board is screwed to each
heatsink with nylon screws and a nylon spacer underneath the board. I
have more detailed pictures and cad drawings for these if any one
wants them. There is a small 3/16 W X 1.32 Dp clearance cut into the
heatsink next to each screw as there is a ground circuit on the edge
of the board at each screw. The clearance cut keeps circuit ground
from coming into contact with chassis ground.
Don
--- In CAD_CAM_EDM_DRO@egroups.com, Matt Shaver <mshaver@e...> wrote:
> Donald Brock wrote:
>
>
> > I just finished assembling two more of Dan's 5 Amp drives and I
have
> > been very impressed with the professional looking results that
have
> > been obtained.
>
> That's a nice job! Is that aluminum channel, or did you mill those
> heatsinks from solid blocks?
>
> Matt
Discussion Thread
Donald Brock
2001-01-22 18:44:30 UTC
Nice results From Dan's kits
Matt Shaver
2001-01-22 21:36:33 UTC
Re: [CAD_CAM_EDM_DRO] Nice results From Dan's kits
Donald Brock
2001-01-22 21:54:09 UTC
Re: Nice results From Dan's kits
Donald Brock
2001-01-22 22:10:11 UTC
Re: Nice results From Dan's kits
wayne_j_hill@h...
2001-01-23 07:35:10 UTC
Re: Nice results From Dan's kits