Re: EMC restarting in middle of program
Posted by
Dan Falck
on 2001-01-30 18:45:48 UTC
I use EMC a lot in my little business, engraving. Sometimes a part that is
finished and overbuffed comes out uneven and has to be re- run. It is easy
to use the "Set run mark" command in the editor to start the machine where
I want to. If I break a tool, it's easy enough to change the tool, reset Z
zero, and then start again in the area of code that it was just in.
Dan
P.S. test.... test....Yahoo test.....Yahoo test......
finished and overbuffed comes out uneven and has to be re- run. It is easy
to use the "Set run mark" command in the editor to start the machine where
I want to. If I break a tool, it's easy enough to change the tool, reset Z
zero, and then start again in the area of code that it was just in.
Dan
P.S. test.... test....Yahoo test.....Yahoo test......