Heidenhain help please

I use a small program called Discriminator as a text editor and
simple simulation program demo is at www.cncedit.com
This come set up for going G Code with very little tweaking.
Problem:
A friend who has a Bridgeport VMC with Heidenhain control is looking
to use this but the simulation side needs different parameters. Has
any body done this with Discriminator and failing that can someone
fill in the blanks below.

Rapids was G00 --?
Linear was G01 ---?
Counterclockwise arcs was G03 --?
Clockwise arcs was G02 --?
Incremental was G91 --?
Absolute was G90 --?
XY Plane was G17--?
XZ Plane was G18 --?
YZ Plane was G19 --?

Drilling codes
G81--?
G82--?
G83--?
g84--?
G85--?
G86--?
G87--?
G88--?

Canned cycle cancel code was G80 --?
Return to initial plane was G98--?
Return to rapid plane was G99 --?
Rapid plane address character was R --?

Many thanks in advance.

John Stevenson
Nottingham, England