Re: [CAD_CAM_EDM_DRO] posting delay
Posted by
wanliker@a...
on 2001-02-10 10:05:40 UTC
I think it often depends on where you are. The posts from the list this
morning were coming thru within 15 minutes, using AOL here in Alb. NM.
However trying to go to the WEB last night was completely hopeless, I think
the entire world was online, things were so slow that almost everything timed
out before I could get to the site.
You can always verify if your message got to YaHoo, by going to:
http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
I think that this list as well as several others are suffering from lack of
postings to a large extent. I am on several, and I now get about 1/2 or less
of normal traffic. And most of them do not go thru YaHoo.
bill
List Mom
morning were coming thru within 15 minutes, using AOL here in Alb. NM.
However trying to go to the WEB last night was completely hopeless, I think
the entire world was online, things were so slow that almost everything timed
out before I could get to the site.
You can always verify if your message got to YaHoo, by going to:
http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
I think that this list as well as several others are suffering from lack of
postings to a large extent. I am on several, and I now get about 1/2 or less
of normal traffic. And most of them do not go thru YaHoo.
bill
List Mom
Discussion Thread
Carlos Guillermo
2001-02-10 07:26:48 UTC
posting delay
Wayne Bengtsson
2001-02-10 07:37:39 UTC
Re: [CAD_CAM_EDM_DRO] posting delay
wanliker@a...
2001-02-10 10:05:40 UTC
Re: [CAD_CAM_EDM_DRO] posting delay
wanliker@a...
2001-02-10 10:14:40 UTC
Re: [CAD_CAM_EDM_DRO] posting delay