WANTED:2-d software for plasma
Posted by
ironarbor@h...
on 2001-02-12 22:59:45 UTC
I have built a cnc plasma table using "supertechs/Dennis" board,
motors and software but am having problems w/software. Does any one
know of any good not so expensive software? We would like to use it
for cutting signs and shapes.we have Nema 23/190 oz motors.
motors and software but am having problems w/software. Does any one
know of any good not so expensive software? We would like to use it
for cutting signs and shapes.we have Nema 23/190 oz motors.