RE: [CAD_CAM_EDM_DRO] Re: back knife lathe (mistake correction)
Posted by
Carlos Guillermo
on 2001-03-01 19:04:39 UTC
Hey !!!
I'm not getting these posts!! I haven't received anything from Ballendo
regarding a back-knife lathe, nor anything from a Jennifer that others are
replying to. What's up??? Is it just me?
Carlos Guillermo
VERVE Engineering & Design
-----Original Message-----
From: Alan Marconett KM6VV [mailto:KM6VV@...]
Sent: Thursday, March 01, 2001 3:43 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Re: back knife lathe (mistake correction)
Hi Ballendo,
Nasty looking machines! I'm SURE that doesn't run on a Sherline! Still
interesting!
Alan KM6VV
ballendo@... wrote:
I'm not getting these posts!! I haven't received anything from Ballendo
regarding a back-knife lathe, nor anything from a Jennifer that others are
replying to. What's up??? Is it just me?
Carlos Guillermo
VERVE Engineering & Design
-----Original Message-----
From: Alan Marconett KM6VV [mailto:KM6VV@...]
Sent: Thursday, March 01, 2001 3:43 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Re: back knife lathe (mistake correction)
Hi Ballendo,
Nasty looking machines! I'm SURE that doesn't run on a Sherline! Still
interesting!
Alan KM6VV
ballendo@... wrote:
><snip>
> Hi all!
>
> I went to double check my post (had a gut feeling) and found that I
> had confused two hi-production lathes used in furniture factories.
> The link below will detail the differences and correct the
> misinformation I posted. I've snipped the pertinent bits for those
> who don't need/want the details...
Discussion Thread
ballendo@y...
2001-03-01 03:02:26 UTC
back knife lathe (mistake correction)
Alan Marconett KM6VV
2001-03-01 12:43:55 UTC
Re: back knife lathe (mistake correction)
Carlos Guillermo
2001-03-01 19:04:39 UTC
RE: [CAD_CAM_EDM_DRO] Re: back knife lathe (mistake correction)