Re: [CAD_CAM_EDM_DRO] Re:dovetail cutting
Posted by
Joe Vicars
on 2001-03-05 05:41:51 UTC
Yes,
Dovetailing (milling) a long groove can be very frustrating especially in steel. You want rough the groove as much as possible
with a key cutter, T-slot tool or similar. It should look like a "T" before you start with the dovetail.
A shaper is really good for dovetailing..
Bradford Chaucer wrote:
Dovetailing (milling) a long groove can be very frustrating especially in steel. You want rough the groove as much as possible
with a key cutter, T-slot tool or similar. It should look like a "T" before you start with the dovetail.
A shaper is really good for dovetailing..
Bradford Chaucer wrote:
> At 03:04 AM 3/5/2001, you wrote:
> >I have been cutting at 160 rpm's and a feed of .002 per rev but I
> >snapped the cutter ,boy $59.00 down the drain and I have 15 more cuts
> >to do..
>
> Were you cutting into solid material or undercutting in an existing
> groove?? I think that you first need to remove the central portion of the
> dovetail slot with a straight sided cutter of the proper diameter
> Regards,
> Bradford Chaucer
> bradford.chaucer@...
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Discussion Thread
Bradford Chaucer
2001-03-05 00:12:27 UTC
Re:dovetail cutting
Joe Vicars
2001-03-05 05:41:51 UTC
Re: [CAD_CAM_EDM_DRO] Re:dovetail cutting