3-Axis 2A Bipolar Chopper Driver Board
Posted by
rad@s...
on 2001-03-12 17:31:11 UTC
Can anyone that has already built this driver board give some help?
I am at the testing part, and I can not seem to get Desknc to do
anything. I did the configure part, and I still get no change on the
ref points on the board. I am at this point in testing the driver
board, have set holding voltage, but can not get the stepping
reference voltage. Has anyone out here had the same problem, do you
know what I am not doing right?
Thanks ahead of time.
Bob Douglass
I am at the testing part, and I can not seem to get Desknc to do
anything. I did the configure part, and I still get no change on the
ref points on the board. I am at this point in testing the driver
board, have set holding voltage, but can not get the stepping
reference voltage. Has anyone out here had the same problem, do you
know what I am not doing right?
Thanks ahead of time.
Bob Douglass