Re: [CAD_CAM_EDM_DRO] Re: Re Servos

well
I hope not if so then they go back I have in writing
that they are 400oz or better ..thanks

John
--- John Stevenson <machines@...> wrote:

> --- In CAD_CAM_EDM_DRO@e..., marble_h@y... wrote:
> > Ok group give me till tuesday to get all the info
> up for you I have
> a
> > lot of checking to do on them like I said some
> have encoders and
> some
> > don't . They have been checked out and running But
> I want to make
> > sure my self they say on them 1nm torque and
> range from 24 to 50
> > volts DC let me check out every thing . I hope I
> got the math
> right
> > at 400oz =1nm they are also 2 to 4 amp rating
> ,they were used on
> > robots
>
> 1 nm = 141.6 oz.in according to by book
>
> Regards
> John Stevenson.
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an
> unmoderated list for the discussion of shop built
> systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe:
> CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe:
> CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com,
> wanliker@...
> Moderator: jmelson@...
> timg@... [Moderator]
> URL to this page:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>

__________________________________________________
Do You Yahoo!?
Get email at your own domain with Yahoo! Mail.
http://personal.mail.yahoo.com/