G41/G42 codes
Posted by
Gordon Robertson
on 2001-03-26 14:34:10 UTC
Well, I tried out going into cutter comp using a circular move this
morning. It works just fine on the schools machine. the machine is
a Hass model VF-0. I have no idea what type of controllers Hass
uses...something proprietary. When going into comp using the
circular move, you have to be sure to make at least one g01 OR
g02/g03 move after going into comp or you'll get an error message.
Wish I'd known that (about going into comp with a circ move)several
years ago when I made that oval grip cap routine...it would have made
the program a lot simpler!
Smoke
morning. It works just fine on the schools machine. the machine is
a Hass model VF-0. I have no idea what type of controllers Hass
uses...something proprietary. When going into comp using the
circular move, you have to be sure to make at least one g01 OR
g02/g03 move after going into comp or you'll get an error message.
Wish I'd known that (about going into comp with a circ move)several
years ago when I made that oval grip cap routine...it would have made
the program a lot simpler!
Smoke