DOS/EMC aka DeskNCrt vs EMC

--- In CAD_CAM_EDM_DRO@y..., "Tim Goldstein" <timg@k...> wrote:

"EMC will put out a very high pulse rate, but there can be some
usability problems..."

I plan to use servos with the Gecko drivers, so resonance won't be a
problem. Mr. Yeager claims that CNC Pro on a Pentium II running at
450 Mhz will produce about 100,000 pulses per second. That sounds
incredible, however I get the impression that he is a person that can
be trusted. The point of my post was to find out if EMC can equal CNC
Pro in pulses per second. From the numbers that you gave, I think
maybe not???

Tom Murray