Re: [CAD_CAM_EDM_DRO] Power supply for (3) Gecko 210 drivers?

Hi Brian,

I think I'd rather have a linear supply, and then take the motor power
directly from the filter cap. Get about 37v that way. the switcher
would probably be adequate, but you might have to have a "minimum"
current draw to get it to regulate. 24v is at the minimum end for the
Gecko's.

Alan KM6VV


Brian wrote:

>
> Hi,
>
> Would a 24V/6.5A switching power supply be adequate for 3 Sherline
> stepper motors on a Sherline lathe? My drivers are Gecko 210s.
>
> If not, what would be a good match for these motors and drivers, and
> where would I get one?
>
> Thank you in advance,
> Brian
>