Re: [CAD_CAM_EDM_DRO] Dream Machine - please make public

Doug, when things are made accessible only when you do "the club
handshake" I am always wary. I too turn back when viewing was not
readily available. Too much really good stuff available without taking
time to jump thru hoops.

Take Care

Bill

----- Original Message -----
From: Doug Fortune <pentam@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, April 03, 2001 7:46 PM
Subject: [CAD_CAM_EDM_DRO] Dream Machine - please make public


> ballendo@... wrote:
>
> > Doug,
> >
> > It takes SECONDS(minutes, with a slow connection) to join and
> > unsubscribe from a group...
>
> I know. What is the harm in allowing the public to view the
> files (without extra steps)?
>
> I am NOT saying: allow the lay public to POST files!
> (That of course is bad for lots of reasons).
>
> Best regards
> Doug Fortune
> http://www.cncKITS.com
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
>
>