New Member Intro, Casting from rapid prototypes
Posted by
Peter Chen
on 2001-04-05 15:05:14 UTC
<jvicars@...: "I have done rapid prototype
castings with varied success. I will tell you that it
is very expensive..........">
What if (expensive) you don't include initial cost of
machine, and you are using corn starch as raw
material?
Re: Zcorp
<Andrew Werby <drewid@...>"... incomplete
burnout using Z-corp models, however, and the surface
is equivalent to a sand-casting.>
One can sand the prototype with very fine sandpaper.
Peter
____________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.co.uk
or your free @... address at http://mail.yahoo.ie
castings with varied success. I will tell you that it
is very expensive..........">
What if (expensive) you don't include initial cost of
machine, and you are using corn starch as raw
material?
Re: Zcorp
<Andrew Werby <drewid@...>"... incomplete
burnout using Z-corp models, however, and the surface
is equivalent to a sand-casting.>
One can sand the prototype with very fine sandpaper.
Peter
____________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.co.uk
or your free @... address at http://mail.yahoo.ie