Re: [CAD_CAM_EDM_DRO] Motor info
Posted by
Rich D.
on 2001-04-12 16:27:03 UTC
Mel,
If you really mean "PH...." I see nothing in the print cat either.
PK266-01B is 124 oz/7.7V/7.4ohm.
The *L* is some kind of spec. Not indicated in my cat either.
An *M* would indicate .9° res.
If this motor were origially ordered as part of a system, the specs
may be specific to a custom order and not follow the general cat rules.
Rich D.
melw@... wrote:
If you really mean "PH...." I see nothing in the print cat either.
PK266-01B is 124 oz/7.7V/7.4ohm.
The *L* is some kind of spec. Not indicated in my cat either.
An *M* would indicate .9° res.
If this motor were origially ordered as part of a system, the specs
may be specific to a custom order and not follow the general cat rules.
Rich D.
melw@... wrote:
>
> I have some of the motors listed below and was worndering
> if any one has any specs on them. I tryed looking them up on the web
> but the manufacturs site did not have this model listed.
> PH266L-01B VEXTA 2-phase 1.8 degrees
> per step 6V 1.2A
> Thanks!
> Mel
Discussion Thread
melw@p...
2001-04-12 12:49:03 UTC
Motor info
indigo_red@q...
2001-04-12 13:36:47 UTC
Re: Motor info
Rich D.
2001-04-12 16:27:03 UTC
Re: [CAD_CAM_EDM_DRO] Motor info
melw@p...
2001-04-12 22:07:29 UTC
Re: Motor info
melw@p...
2001-04-12 22:08:11 UTC
Re: Motor info
NCS
2001-04-15 16:59:42 UTC
Re: Motor info