Re: Drawing a Parabola ?
Posted by
Rich D.
on 2001-04-13 19:09:15 UTC
Jeff and all,
Thankyou very much for your help. Jeff sent a Lisp file to me
and it's just what the doctor ordered. Generates the parabola
perfectly in a polyline form (not the dreaded spline) that only
needs exploding to seperate entities for g-code in a snap.
I will be, hopefully, machining a reflector for a miniature
locomotive on a temporary lathe CNC setup.
Borrowed plastic flashlight units can't stand the
heat above the boiler.
Rich D.
abscissa wrote:
Thankyou very much for your help. Jeff sent a Lisp file to me
and it's just what the doctor ordered. Generates the parabola
perfectly in a polyline form (not the dreaded spline) that only
needs exploding to seperate entities for g-code in a snap.
I will be, hopefully, machining a reflector for a miniature
locomotive on a temporary lathe CNC setup.
Borrowed plastic flashlight units can't stand the
heat above the boiler.
Rich D.
abscissa wrote:
>
> try this, from the old Compuserve Acad Forum
>
> parabola.lsp
>
> save to c:\acad\support
>
> (load"parabola")<Enter>
> parabola<Enter>
>
Discussion Thread
Rich D.
2001-04-13 19:09:15 UTC
Re: Drawing a Parabola ?
Elliot Burke
2001-04-14 01:27:27 UTC
re:Re: Drawing a Parabola ?